Filter
Top Products
17-26 Preliminary May 9, 2000 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide
Configuring DSL Connections (DSLTNT)
Sample DSL configurations
– Name=idsl-fr
– Active=Yes
– Call Type=Nailed
– Nailed Grp=1
3 Exit the Frame Relay profile and save your changes.
Note that the Pipeline uses the following nailed group numbers:
• 1 is the first B channel
• 2 is the second B channel
Configuring the Connection profile
You must configure other, specialized options in the Connection profile for the DSLTNT,
including the name of the Frame Relay profile and the nailed group assigned to it. To do this,
proceed as in the following example:
1 Open Ethernet > Connections > idsltnt
2 Specify Frame Relay encapsulation:
Encaps=FR
3 Open the Encaps Options submenu.
4 Specify name of the Frame Relay profile used by this connection and a DLCI.
– FR Prof=idsl-fr
– DLCI=16
5 Exit and save the Connection profile.
Sample ADSL nailed PPP connection
In Figure 17-4, a DSLPipe connects to a DSLTNT ADSL card over a nailed PPP connection.
The ADSL card is in slot 7, and the DSLPipe is connected to port 3 of the ADSL card. The
DSLPipe IP address is 10.10.73.1/24. The DSLTNT IP address is 104.178.115.163/24. This
example uses ADSL, but you can configure an SDSL connection similarly.
Figure 17-4. Sample ADSL PPP connection
10.10.73.1/24
Nailed PPP
COE (MAX TNT)
10.10.73.2/24
CPE (DSLPipe)
MAX TNT system IP adress
104.178.115.163/24