Filter
Top Products
10-4 Preliminary May 9, 2000 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide
Configuring E1 FrameLine Cards (MAX TNT, DSLTNT)
Administrative profiles for E1 FrameLine
hunt-grp-phone-number-2 = ""
hunt-grp-phone-number-3 = ""
To configure the E1 FrameLine card:
admin> read E1 {1 2 2}
UE1/{ shelf-1 slot-2 2 } read
admin> set enabled = yes
admin> list channel 1
channel-usage = unused-channel
trunk-group = 9
phone-number = ““
call-route-info = { any-shelf any-slot 0 }
nailed-group = 0
admin> set channel-usage = nailed-64-channel
admin> set nailed-group = 3
admin> list .. 2
channel-usage = unused-channel
trunk-group = 9
phone-number = ““
call-route-info = { any-shelf any-slot 0 }
nailed-group = 0
admin> set channel-usage = nailed-64-channel
admin> set nailed-group = 3
Continue configuring the rest of the channels similarly. When you have finished, write the
profile:
admin> write
UE1/{ shelf-1 slot-2 2 } written
Administrative profiles for E1 FrameLine
In addition to the E1 profile described in the previous section, the following administrative
profiles apply to the E1 FrameLine slot card:
• Admin-State profile
• Device-State profile
• Slot-Info profile
• T1-Status profile
This section explains the changes to these profiles to support the E1 FrameLine card.