Filter
Top Products
Configuring DSL Connections (DSLTNT)
Sample DSL configurations
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide Preliminary May 9, 2000 17-29
2 Specify the following values:
– Chan Usage=Leased/Unused
– My Name=dslpipe
– My Addr=10.10.73.1/24
– Rem Name=max-tnt
– Rem Addr=104.178.115.163/24
– Route=IP
– Bridge=No
3 From the Main Edit menu, select Ethernet > Connections > max-tnt.
4 Specify the following values:
– Active=Yes
– Encaps=PPP
– Bridge=No
– Route IP=Yes
5 Open the Encaps Options submenu.
6 Specify the following values:
– Send Auth=PAP
– Send PW=PAP
– Recv PW=PAP
– Link Comp=None
– VJ Comp=No
7 Open the Telco Options submenu.
8 Specify the following values:
– Call Type=Nailed
– Group=1
9 Exit the Connection profile and save your changes.
Sample SDSL Frame Relay configuration using numbered interfaces
This section describes a common SDSL application. In this example, the SDSL line is a leased
connection over a single pair of wires, using Frame Relay as the transport protocol (see
Figure 17-5). The example uses interface-based routing on a point-to-point link. Each side of
the connection is assigned a unique address that applies only to the connection.
This example uses SDSL, but you can configure an ADSL connection similarly.