Filter
Top Products
Configuring DSL Connections (DSLTNT)
Sample DSL configurations
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide Preliminary May 9, 2000 17-33
Configuring the DSLPipe-S
This section provides an example of configuring the SDSL Pipeline (DSLPipe-S). For
complete information about configuring the DSLPipe-S, see the documentation that came with
your Pipeline unit.
Before you configure the Pipeline, make sure of the following:
• The PC connected to the Pipeline has an IP address on the same subnet as the Pipeline.
• The IP address of the Pipeline is configured as the default gateway for the PC.
To configure the Pipeline:
1 From the Main Edit menu, select Configure.
2 Specify the following values:
– Chan Usage=Leased/Unused
– My Name=sdsl-pipeline
– My Addr=192.168.216.1/24
– Rem Name=max-tnt
– Rem Addr=192.168.23.142/30
– Route=IP
3 Exit and save the Configure profile.
4 From the Main Edit menu, select Ethernet > Connections > max-tnt.
5 Specify the following values:
– Active=Yes
– Encaps=FR
– Route IP=Yes
6 Open the Encaps Options submenu.
7 Specify the following values:
– FR Prof=Frame Relay
– DLCI=16
8 Open the IP options submenu.
9 Specify the following values:
– LAN Adrs=192.168.23.142/30
– WAN Alias=0.0.0.0
– IF Adrs=192.168.23.141/30
10 Exit the Connection profile and save your changes.
Next, set up the Frame-Relay profile.
1 Open the Ethernet > Frame Relay > Frame Relay profile.