Filter
Top Products
Configuring E1 Cards
Configuring E1 R2 signaling
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide Preliminary May 9, 2000 9-11
To configure the line for R2 signaling, proceed as in the following example:
admin> read e1 {1 2 2}
E1/{ shelf-1 slot-2 2 } read
Number-Complete Number of digits considered to be a complete number on an incoming
call using R2 signaling. You can specify End-of-Pulsing to have the
TAOS unit continue receiving digits until the caller stops sending
them, or you can specify a fixed number of digits (up to 10). In all
cases, the digits received before the call is answered are considered the
called number for call-routing purposes.
Group-B-Answer-
Signal
Replaces the Group-B-Signal parameter found in earlier releases. It
specifies the group-B signal that the TAOS unit sends before
answering a call, and can be set to a value from Signal-B-1 to
Signal-B-15. The default is Signal-B-6, which is the recommended
setting for E1_R2 Israeli signaling.
Group-B-Busy-Signal Group-B-Busy-Signal specifies the group-B signal that the TAOS unit
sends as a busy signal. When the TAOS unit does not have sufficient
resources to handle the call correctly (for example, if all of its modems
are busy), it sends the group-B signal specified by this parameter. It
can be set to a value from Signal-B-1 to Signal-B-15. The default is
Signal-B-3, which is the recommended setting for E1_R2 Israeli
signaling.
Group-II-Signaling Group II signal that is sent in the course of an outgoing call,
immediately after acknowledgment by the called end that all necessary
address digits have been received. It is used for outgoing call
configuration.
Caller-ID Enables or disables the use of caller ID for R2 calls. You must specify
one the following signaling modes to enable the TAOS unit to process
CLID information received from the switch:
• E1-Argentina-Signaling
• E1-Brazil-Signaling
• E1-Chinese-Signaling
• E1-India-Signaling
• E1-Israel-Signaling
• E1-Kuwait-Signaling
• E1-Malaysia-Signaling
• E1-Mexico-Signaling
• E1-New-Zealand-signaling
• E1-Philippine-Signaling
• E1-Thailand-Signaling
For details about configuring CLID authentication in a Connection
profile, see the APX 8000/MAX TNT/DSLTNT WAN, Routing, and
Tunneling Configuration Guide.
Parameter Specifies