Filter
Top Products
13-2 Preliminary May 9, 2000 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide
Configuring Unchannelized DS3 Cards (MAX TNT, DSLTNT)
Overview of unchannelized DS3 configuration
Overview of unchannelized DS3 configuration
Table 9-1 lists the sections describing common tasks you might have to perform to configure
an unchannelized DS3 line. The table includes a brief description of each task, and lists the
parameters you will use.
For complete information about the associated parameters, see the APX 8000/MAX
TNT/DSLTNT Reference.
Using the UDS3 profile
When the unit first detects the presence of an unchannelized DS3 slot card, it creates a default
(UDS3) profile for the card. For example, after installing an unchannelized DS3 slot card in
slot 7, you can verify the creation of a UDS3 profile as follows:
admin> dir uds3
7 03/21/1997 21:12:03 { shelf-1 slot-7 0 }
The following example shows the parameters in a UDS3 profile, with sample settings:
admin> read uds3 { 1 7 1}
UDS3/{ shelf-1 slot-7 1 } read
admin> list
name = 1:7:1
physical-address* = { shelf-1 slot-7 1 }
enabled = yes
line-config = { 0 131 static { any-shelf any-slot 0 } c-bit-parity+
trunk-group = 0
nailed-group = 131
activation = static
call-route-info = { any-shelf any-slot 0 }
line-type = c-bit-parity
line-coding = b3zs
loopback = no-loopback
Configuring the UDS3 physical link
In an unchannelized DS3 (UDS3) profile, the Name parameter enables you to assign the
profile a name of up to 16 characters. It is displayed after the line’s physical address in the Dir
command output.
Table 13-1. Unchannelized DS3 line configuration tasks
Task Description Associated parameters
“Using the UDS3 profile” on
page 13-2
The unit creates a single unchannelized DS3
profile when you install the unchannelized
DS3 slot card, which you use to configure the
card.
N/A
“Configuring the UDS3 physical
link” on page 13-2
Assign a name and enable the unchannelized
DS3 line.
Name
Enabled