Filter
Top Products
Configuring E1 Cards
Making a profile the working profile
APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide Preliminary May 9, 2000 9-5
• Rate adaption protocol—DASS 2 and DPNSS only (X.30 and V.110)
Note: The TAOS unit cannot receive multichannel calls using Multilink Protocol (MP)
encapsulation unless all channels of the call share a common telephone number (namely, a
hunt group). You can request that your service provider supply you with a hunt group.
Making a profile the working profile
When the TAOS unit system detects that an E1 card has been installed, it creates a default E1
profile for each of the eight lines on the card.
In the following display example, the Dir command shows eight default E1 profiles created for
a card installed in slot 2:
admin> dir e1
305 12/11/1996 15:58:20 { shelf-1 slot-2 2 }
305 12/11/1996 15:58:20 { shelf-1 slot-2 4 }
305 12/11/1996 15:58:20 { shelf-1 slot-2 5 }
305 12/11/1996 15:58:20 { shelf-1 slot-2 6 }
305 12/11/1996 15:58:20 { shelf-1 slot-2 7 }
305 12/11/1996 15:58:20 { shelf-1 slot-2 8 }
320 12/20/1996 20:55:31 { shelf-1 slot-2 3 }
317 01/08/1997 09:58:55 { shelf-1 slot-2 1 }
By default, a line is not enabled, which means that it is not available for use. Its default
signaling method is inband, typically used for channelized connections.
To configure an E1 profile, make it the working profile by reading it into the edit buffer. For
example:
admin> read e1 {1 2 1}
E1/{ shelf-1 slot-2 1 } read
Once you have read in a profile, it remains the working profile until you read in another
profile. You can use the Set command to change one or more of the profile’s parameters.
To save your configuration changes, use the Write command. For example,
admin> write
E1/{ shelf-1 slot-2 1} written
To list the parameters in an E1 profile, use the List command, as in the following example:
admin> list
physical-address* = { shelf-1 slot-2 1 }
line-interface = { yes esf b8zs eligible middle-priority
isdn wink-star+
The following example shows the parameters in an E1 profile, with sample settings:
[in E1/{ shelf-1 slot-15 5 }]
name = ""
physical-address* = { shelf-1 slot-15 5 }