Filter
Top Products
5-4 Preliminary May 9, 2000 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide
Configuring Series56 II and III Modem and Hybrid Access Cards
Series56 II and III Call-Route profiles
rate and the AT-Answer-String parameter specifies a different baud rate, the answer string
overwrites the configured maximum baud rate.
Following is the relevant parameter, which is shown with its default setting:
[in TERMINAL-SERVER:modem-configuration]
AT-answer-string = ""
The value of this parameter must be valid AT commands, up to 36 characters. Do not begin the
string with AT. An AT is appended to the beginning of this string automatically before it is sent
to the modem. Also, do not include an A (answer) or a D (dial) command anywhere in the
string. An A command is appended automatically to the end of this string, and a D command in
the answer string causes the call to fail.
Note: Be very careful when entering AT commands in this parameter. The system does not
prevent you from entering incorrect strings.
The following example sets the AT-Answer-String parameter to S37=11, which causes the
following string to be sent to the modem:
ATS37=11A
When the modem receives this string, it forces a V.32bis 14400 connection.
admin> read terminal-server
TERMINAL-SERVER read
admin> set modem AT-answer-string = S37=11
admin> write
TERMINAL-SERVER written
Series56 II and III Call-Route profiles
When you install a Series56 II or Series56 III slot card, the TAOS unit creates two call route
profiles for each channel on the card. One for a digital data call and one for a modem voice
call. For example:
admin >callroute -d
device # source type tg sa phone
1:14:01/0 0 0:00:00/0 voice-call-type 0 0
1:14:01/0 1 0:00:00/0 digital-call-type 0 0
1:14:02/0 0 0:00:00/0 voice-call-type 0 0
1:14:02/0 1 0:00:00/0 digital-call-type 0 0
1:14:03/0 0 0:00:00/0 voice-call-type 0 0
1:14:03/0 1 0:00:00/0 digital-call-type 0 0
1:14:04/0 0 0:00:00/0 voice-call-type 0 0
1:14:04/0 1 0:00:00/0 digital-call-type 0 0
1:14:05/0 0 0:00:00/0 voice-call-type 0 0
1:14:05/0 1 0:00:00/0 digital-call-type 0 0
Note that in Call-Route profiles, voice-call-type refers only to a modem call.