Filter
Top Products
17-14 Preliminary May 9, 2000 APX 8000/MAX TNT/DSLTNT Physical Interface Configuration Guide
Configuring DSL Connections (DSLTNT)
Configuring DSLPipe Plug and Play
TFTP Host Name=host-1.abc.com
Boot File Path=/tftpboot/config
For a Pipeline unit to operate as a DHCP server, DHCP Spoofing and Always Spoof must be
set to Yes. To enable the server to return an IP address, netmask, path to a more detailed
configuration file, and TFTP server name, configure the following parameters:
• Set the IP Group 1 parameter and Group 1 Count parameters to represent a valid IP
address pool.
• Set the TFTP Host Name parameter to the hostname of the TFTP server on which the
DSLPipe configurations reside.
• Set the Boot File Path parameter to the directory on the TFTP server that contains the
DSLPipe configurations.
For details on the other settings, see the documentation for the Pipeline unit.
TFTP server requirements
In this sample configuration, the TFTP server uses the /tftpboot/config directory to
store configuration files. This is consistent with the DHCP configuration shown in the
preceding section, which passes the following pathname to the DSLPipe client:
/tftpboot/config
The filename of a DSLPipe configuration file must match the unit’s serial number. DSLPipe
serial numbers are located on a label on the bottom of the unit and in the 00-100 status window.
DSLPipe default configuration
In its default configuration, the DSLPipe is configured as follows:
In this menu: These are the defaults:
Configure Route=None
Bridge=Yes
My Name=DSLPipe
Ethernet > Connections Station=DSLPipe
Active=Yes
Encaps=FR
Ethernet > Connections > Encaps Options FR Prof = DSLframe
DLCI=16
Ethernet > Frame Relay Name=DSLframe
Active=Yes
FR Type=DTE
Link Mgmt=T1.617D