Filter
Top Products
4
SETUP AND PROCEDURES BEFORE OPERATION
4.2 Setup and Procedures before Operation
4 - 3
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
4.2 Setup and Procedures before Operation
Figure 4.2 Procedures and setting before system operation
Initial setting and automatic refresh setting
The program can be simplified if the utility
package is used for setting.
Programming and debugging
Create and check the sequence program.
NO
YES
Use the utility package?
Offset/gain setting
If user range settings are used, perform the
offset and gain settings.
Use factory default settings
Use user range settings?
Use user range settings
Intelligent function module switch settings
Perform settings using GX Developer.
Module mounting
Mount the Q68TD-G-H02(H01) in the specified slot.
Start
Wiring
Wire the thermocouple and cold junction temperature
compensation resistor to the Q68TD-G-H02(H01).
If the terminal block is used, connect the thermocouple
and cold junction temperature compensation resistor
to it. Then wire the terminal block to the
Q68TD-G-H02(H01).
(Refer to CHAPTER 5).