Filter
Top Products
6
PROGRAMMING
6.1 Programming Procedure
6 - 2
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
6.1 Programming Procedure
Create a program that executes temperature input of the Q68TD-G-H02(H01) in the
following procedure.
Figure 6.1 Programming chart
NO
Set the disconnection detection conversion setting
(Q68TD-G-H02 only) or disconnection state conversion setting
(Q68TD-G-H01 only).
(Set any value for the disconnection detection
conversion setting (Q68TD-G-H02 only) or disconnection
state conversion setting (Q68TD-G-H01 only).)
Disconnection detection signal (Q68TD-G-H02 only)
Disconnection detection flag (Q68TD-G-H02 only)
Disconnection state monitor signal
(Q68TD-G-H01 only)
Disconnection state monitor flag
(Q68TD-G-H01 only)
YES
Averaging processing selection
Sampling processing
Time average
Count average
Moving average
Primary delay filter
Start
Use the utility package?
Conversion enable/disable setting
Averaging process selection
NO
<Select any of them>
Up scale
Down scale
Given value
Operating condition setting request (Y9)
processing
Measured temperature value read
End
Procedure to judge
disconnection status
monitor?
Measured temperature value
Output a scaling value?
Set the scaling range setting
Perform warning output?
Initial settings, Auto refresh
setting
Warning output enable/disable
Process alarm upper/lower limit values
Rate alarm warring detection period
Rate alarm upper/lower limit values
<Set depending on necessity>
YES
YES
NO
(Refer to Section 6.2.2,
Section 6.3.1)
Initial setting
(Refer to
Section
6.2.3)