Filter
Top Products
6 - 9
6.2 Using Programs in Normal System Configuration
6.2.2 Program example when Configurator-TI
6
PROGRAMMING
1) Click the Initial setting button of the setting target channel.
In this program example, CH1 to CH3 are the setting target.
Since CH4 to CH8 are not used, setting is not required.
Figure 6.9 Initial setting screen
2) The following screen is displayed by clicking the Initial setting button of each
channel. (The following is the example of CH1.)
Set the iniail setting items listed in Table 6.3.
Figure 6.10 CH1 Initial setting screen