Filter
Top Products
6
PROGRAMMING
6.2 Using Programs in Normal System Configuration
6.2.2 Program example when Configurator-TI
6 - 10
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
(b) Auto refresh setting (Refer to Section 5.5)
Set devices in which the measured temperature values, warning output flags,
disconnection detection flags, and error codes of CH1 to CH3 are to be stored.
For the devices in the PLC side Device field, refer to "List of devices" at (1) in this
section.
Figure 6.11 Auto refresh setting
(c) Writing intelligent function module parameters (Refer to Section 5.3.3)
Write the intelligent function module parameters to the CPU module. Perform this
operation on the screen for selecting a target intelligent function module.