Filter
Top Products
7
ONLINE MODULE CHANGE
7.3 Online Module Change Procedure
7.3.2 When factory default is used and initial setting was made with sequence program
7 - 11
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
(4) Operation check
(a) To make an operation check, click the button to cancel control
resumption.
Figure 7.17 Cancel of control resumption
(b) Click the button to leave the "Online module change" mode.
Figure 7.18 "Online module change" mode stop
(c) Click the button to close the System monitor screen.
Figure 7.19 "System Monitor" screen
(d) Enable the conversion of the channel to be used in Conversion enable/disable
setting (Un\G0), and turn Operating condition setting request (Y9) from OFF to
ON.