Filter
Top Products
7 - 22
7.3 Online Module Change Procedure
7.3.4 When user range setting is used and initial setting was made with GX Configurator-TI (other system
7
ONLINE MODULE CHANGE
(e) Monitor the CH Measured temperature value (Un\G11 to Un\18) to check that
proper conversion has been made.
Figure 7.42 "CH Monitor/test" screen
(5) Resumption of control
(a) After choosing [Diagnosis] - [Online module change] on GX Developer to
redisplay the "Online module change" screen, click the button to resume
control. Module ready (X0) turns on.
Figure 7.43 Resumption of control
(b) The "Online module change completed" screen appears.
Figure 7.44 "Online module change completion" screen