Filter
Top Products
7
ONLINE MODULE CHANGE
7.3 Online Module Change Procedure
7.3.1 When factory default is used and initial setting was made with GX Configurator-TI
7 - 7
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
(b) Click the button to leave the "Online module change" mode.
Figure 7.7 "Online module change" mode stop
(c) Click the button to close the System monitor screen.
Figure 7.8 "System Monitor" screen
(d) Monitor the CH Measured temperature value (Un\G11 to Un\G18) to check that
proper conversion has been made.
Figure 7.9 "CH Monitor/test" screen