Filter
Top Products
7
ONLINE MODULE CHANGE
7.3 Online Module Change Procedure
7.3.4 When user range setting is used and initial setting was made with GX Configurator-TI (other system
7 - 21
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
(4) Operation check
(a) To make an operation check, click the button to cancel control
resumption.
Figure 7.39 Cancel of control resumption
(b) Click the button to leave the "Online module change" mode.
Figure 7.40 "Online module change" mode stop
(c) Click the button to close the System monitor screen.
Figure 7.41 "System Monitor" screen
(d) On the OMC refresh data screen of GX Configurator-TI, set the prerecorded
values and make a OMC refresh data write request. (Refer to Section 5.6.3.)