Filter
Top Products
Instruction Manual
IB-106-300NH Rev. 4.3
May 2005
5-12 General User Interface (GUI) Operation Rosemount Analytical Inc. A Division of Emerson Process Management
World Class 3000
Table 5-5. SETUP Sub-Menu
SUB-MENU
SELECTION PARAMETERS DESCRIPTION
Calibration High Gas ____% O
2
Value of high O
2
calibration gas (0.1000% - 25.00%
O
2
).
Low Gas ____% O
2
Value of low O
2
calibration gas (0.1000% - 25.00%
O
2
).
Auto Cal YES/NO MPS required for Auto Cal.
Output Tracks YES/NO NO, locks output during calibration.
Cal Intrvl XD XH Select time between calibrations in number of days
and hours (1 year max).
Next Cal XH Time until next calibration in number of hours
(1 year max).
Gas Time 0:30 - 20:00
Amount of time calibration gases will be turned on in
number of minutes and seconds; allow enough time
for signal values to stabilize.
Purge Time 0:30 - 20:00 Amount of time for gas lines to clear of calibration
gas.
Res Alarm 50 W – 10 kW Resistance alarm set from 50 to 10,000 ohms.
O
2
Calculation Slope ____ mV/D
Constant ____ mV
Set Point ____°C
Set value between 34.5 and 57.5.
Set value between -20.0 and +20.0 mV.
Set either 736 for World Class 3000 probes or 843
for 218 probes.
Ensure the correct voltage is selected when using HPS 3000 with either World
Class 3000 probes or 218 probes. Refer to Figure 2-13, Jumper Selection Label
for proper voltage selections. If incorrect SET POINT is selected, damage to
the probe may occur.
Reset slope and constants. Press ENTER to reset slope and constants to values
from the latest successful calibration.
O
2
Alarms Hi Alarm ____% O
2
Lo Alarm ____% O
2
Alarm DB ____% O
2
Set value for high alarm limit (0.1000% - 25.00%).
Set value for low alarm limit (0.1000% - 25.00%).
Set value for alarm dead band (0.0000% - 25.00%).
Efficiency Calc. Enable Calc. YES/NO
K1 Value _______
K2 Value _______
K3 Value _______
Select YES to enable, NO to disable.
Set between 0.0000 and 1.000. Refer to Table 5-6.
Set between 0.0000 and 1.000. Refer to Table 5-6.
Set between 1.000 and 20.00. Refer to Table 5-6.