Filter
Top Products
⎯ 98 ⎯
6 F 2 S 0 8 5 7
To correct the entered numerical value, do the following.
• If it is before pressing the
ENTER
key, press the
CANCEL
key and enter the new
numerical value.
• If it is after pressing the
ENTER
key, move the cursor to the correct line by pressing the
and
keys and enter the new numerical value.
Note: If the
C
A
NC
EL
key is pressed after any entry is confirmed by pressing the
E
N
TE
R
key, all
the entries made so far on the screen concerned are canceled and the screen returns to the upper
one.
To enter a text string
Text strings are entered in the bracket under the "Plant name" or "Description" screen.
To select a character, use keys 2, 4, 6 and 8 to move the blinking cursor down, left, right and up.
"
→" and "←" on each of lines 2 to 4 indicate a space and backspace, respectively. A maximum of
22 characters can be entered within the brackets.
/3 Plant name ]_[
→←
ABCDEFGHIJKLMNOPQRSTUVWXYZ ()[]@_
abcdefghi
j
klmno
p
q
rstuvwx
y
z {}*/+-<=>
0123456789 !”#$%&’：；，．^`
→←
→
←
• Set the cursor position in the bracket by selecting "→" or "←" and pressing the
ENTER
key.
• Move the blinking cursor to select a character.
• Press the
ENTER
to enter the blinking character at the cursor position in the brackets.
• Press the
END
key to confirm the entry and return to the upper screen.
To correct the entered character, do either of the following.
• Discard the character by selecting "←" and pressing the
ENTER
key and enter the new
character.
• Discard the whole entry by pressing the
CANCEL
key and restart the entry from the first.
To complete the setting
Enter after making entries on each setting screen by pressing the
ENTER
key, the new settings
are not yet used for operation, though stored in the memory. To validate the new settings, take the
following steps.
• Press the
END
key to the upper screen. Repeat this until the confirmation screen shown
below is displayed. The confirmation screen is displayed just before returning to the "Setting
(change)" sub-menu.
/2 **************
Change settings?
ENTER=Yes CANCEL=No
• When the screen is displayed, press the
ENTER
key to start operation using the new settings,
or press the
CANCEL
key to correct or cancel entries. In the latter case, the screen turns back
to the setting screen to enable re-entries. Press the
CANCEL
key to cancel entries made so far