Filter
Top Products
⎯ 147 ⎯
6 F 2 S 0 8 5 7
• Press 3 (= Timer) on the "Test" sub-menu screen to display the "Timer" screen.
• Enter the number corresponding to the timer to be observed. The timers and assigned
numbers are listed in Appendix C.
• Press the
END
key to display the following screen.
/2
Press ENTER to operat
e
.
CANCE
to cancel
.
L
Press
Timer
• Press the
ENTER
key to start measuring the time. The "TESTING" LED turns on, and
timer is initiated and the following display appears. The input and output signals of the
timer can be observed at monitoring jacks A and B respectively.
Check that the measured time is within
± 10ms of the setting time.
During the test, the following display appears on the LCD and the LEDs above the jacks are
also lit if the input or output signal exists.
/2
Press END to reset
.
CANCE
to cancel
.
L
Press
Timer
Operatin
g.
.....
• Press the
END
key to reset the input signal to the timer. The "TESTING" LED turns off.
• Press the
CANCEL
key to test other timers. Repeat the above testing.