Filter
Top Products
⎯ 104 ⎯
6 F 2 S 0 8 5 7
<BITRN>
•
Enter the number of event to record the status change both to "On" and "Off". If enter 20, both
status change is recorded for EV1 to EV20 events and only the status change to "On" is
recorded for EV21 to EV128 events.
<EV∗>
•
Enter the signal number to record as the event in Appendix B. It is recommended that this
setting can be performed by RSM100 because the signal name cannot be entered by LCD
screen. (Refer to Section 3.4.2.)
Setting the disturbance recording
•
Press 3 (= Disturbance record) to display the "Disturbance record" screen.
e
2 = S c h e
m s w i t c h
/
3 D i s t u r b
a
n
ce
rec rod
gis
nay
3 = B i n r a
l
1 = R e c o r
mt i e t& star er
d
• Press 1 (= Record time & starter) to display the "Record time & starter" screen.
2OCPG( 0.10- 20.00): 1.00 pu
1OCPG( 0.05- 20.00): 1.00 pu
2OCPS( 0.10- 20.00): 1.00
p
u
1OCPS( 0.10- 20.00): 1.00 pu
/ ４ R e c o r d t i m e & s t a r t e r 1/5
Time ( 0.1- 3.0): 1.0 _ s
• Enter the recording time and starter element settings.
To set starters, do the following:
• Press 2 (= Scheme switch) on the "Disturbance record" screen to display the "Scheme switch"
screen.
3
T RI P 0 = fOf 1 1
=On
T RI P
2
1
0 = Off 1=On
T RI P 1 0 = Off 1=On
E VE N 1 0 = Off 1=On
T
: 1 : :
/
4S c h e m e s w i t c 1
/
4 1 h
1
3
• Enter 1 to use as a starter or enter 0 if not to use.
• Press 3 (= Binary signal) on the "Disturbance record" screen to display the "Binary signal"
screen.
SIG4 ( 0- 3071): 4
SIG3 ( 0- 3071): 3
SIG2 ( 0- 3071): 2
/４ Binary signal 1/32
SIG1 ( 0- 3071): 1_
SIG32( 0- 3071): 0
• Enter the signal number to record binary signals in Appendix B. It is recommended that this