Filter
Top Products
⎯ 105 ⎯
6 F 2 S 0 8 5 7
setting can be performed by RSM100 because the signal name cannot be entered by LCD
screen. (Refer to Section 3.4.3.)
4.2.6.6 Status
To set the status display described in Section 4.2.4, do the following.
Press 5 (= Status) on the "Setting (change)" sub-menu to display the "Status" screen.
3=Time zone
2=Time synchronization
/2 Status
1=Metering
Setting the metering
•
Press 1 (= Metering) to display the "Metering" screen.
/
3 Metering 1
/
1
D
i
s
p
l
a
y
v
a
l
u
e
1
=
P
r
i
m
a
r
y
2
=
S
e
c
o
n
r
y
d
a
_
1
• Enter the selected number and press the
ENTER
key. Repeat this for all items.
Setting the time synchronization
The calendar clock can run locally or be synchronized with external IRIG-B time standard signal,
RSM clock, IEC60870-5-103(IEC) or SNTP. This is selected by setting as follows:
• Press 2 (= Time synchronization) to display the "Time synchronization" screen.
Current No.=0 Select No.=_
/3 Time synchronization
0=Off 1=IRIG 2=RSM 3=IEC 4=SNTP
• Enter the selected number and press the
ENTER
key.
Note: When to select IRIG-B, RSM, IEC, or SNTP, check that they are active on the "Time
synchronization source" screen in "Status" sub-menu. If it is set to an inactive IRIG-B, RSM,
IEC, or SNTP, the calendar clock runs locally.
Setting the time zone
When the calendar clock is synchronized with the IRIG-B time standard, it is possible to transform
GMT to the local time.
• Press 3 (= Time zone) to display the "Time zone" screen.
GMTm ( -59- +59): +0 min
/3 Time zone 1/2
GMT ( -12- +12): +9 _ hrs
• Enter the difference between GMT and local time. Enter a numerical value to GMT (hrs) and
GMTm (min), and press the
ENTER
key.