Filter
Top Products
OfficeServ 7100 Call Server Programming Guide
Samsung Business Communications 2-313
(continued)
No Parameter Description Default
14 PROVISIONAL
TIME
After receiving the Provision Response, the User Agent
waits for this length of time until Timeout ends. The range
is 0~999900 ms.
180000 m
15 INV.NO RESP
TIME
Before sending Cancel for the Invite Request, the User
Agent waits for this length of time. The range is
0~99900 ms.
5000 ms
16 GEN.NO
RESP TIME
Before sending Cancel for General Request, the User
Agent waits for this length of time. The range is
0~99900 ms.
5000 ms
17 REQ.RETRY
TIME
After sending General Request, the User Agent waits for
the Final Response for this length of time. The range is
0~99900 ms.
5000 ms
18 SIP SERVER
ENABLE
Sets ENABLE or DISABLE to use an optional, external
industry-standard SIP Server.
DISABLE
20 SIP SERVER
IP
Sets SIP server IP address. 0.0.0.0.
28 SIP SERVER
PORT
Sets the port to use on the SIP Server. 5060
29 SIGNAL PORT Indicates the port number for SIP signalling and sets a
range of numbers allowed by firewall equipment. The
common and default IP path or port used is 10000.
10000
32 SEND CLIP
TABLE
Refers to SEND CLI NUMBER(MMC 323), which pro-
vides calling party identification when using the MGI as a
SIP gateway.
This provides station ID of the calling station. A single-
digit value corresponding to the desired table in MMC
323 should be entered here. This is only used when
MMC 405 value is null.
1
33 INCOMING
MODE
This option selects how incoming calls are routed when
the MGI is used as a SIP gateway.
0 FOLLOW TRUNK RING: Follows MMC 406
1 FOLLOW DID TRANS: Follows MMC 714(default)
2 FOLLOW INCOM DGT: Follows MMC 724
FOLLOW DID
TRANS
34 ALLOW GW
CHECK
When using a gatekeeper, this permits the SIP gateway
to check for gatekeeper presence.
DISABLE
35 REGIST T-GW
NUM
System number when registering as a trunking gateway. 4100
36 REGIST S-GW
NUM
System number when registering as a gateway for sta-
tions.
4200
37 CLIR WITH
NUMBER
When this option is enabled, the CLIP number is sent to
the network even if the CLIP restriction flag is set.
DISABLE