Filter
Top Products
OfficeServ 7100 Call Server Programming Guide
Samsung Business Communications 2-213
[714] DID NUMBER AND NAME TRANSLATION
Assigns an incoming DID call to a specific ring plan destination. It also provides a call
waiting option, if needed, so that a second incoming DID call can be received. The table is
also used to define which MOH source a caller to that DID number will hear when placed
on hold. A name up to 11 characters can be added to the number. There is a maximum of
999 entries. If there is no matching number on DID service, the call is routed to the opera-
tor group.
Option Description
DGT Digits to be received from Trunk line.(up to 16 digits may be entered)
MOH SOURCE Allows the technician to select what the calling party will hear if the call is
placed on hold. There are four possible music selections.
PRI DID priority option. There are nine priority levels: priority 1 is the highest
and priority 9 is the lowest. When calls come into a station group and all
group members are busy, the system will assign a priority to the DDI
numbers so that calls from a high-priority DDI number will be placed at the
front of the group queue. If this option is set to NO, the call held longest in
the group queue has the highest priority.
RING PLAN
1: XXX, 2: XXX,
3: XXX, 4: XXX,
5: XXX, 6: XXX
Ring plan and destination during each ring plan. The destination can be a
station, station group, trunk or trunk group. If a trunk or trunk group is se-
lected the trunks must be programmed as E & M trunks to allow the re-
ceived digits to be re-sent. This is referred to as DID Repeat digits over tie
line. Entering the character ‘B’ means to repeat the received digits.
CW Call Waiting Yes/No.(Allows a second DID call to be received.)
MC The maximum call count. When this is set to 99, the feature will not work. When
set to 0, if a call comes in that matches DID digits and DGT field then the sys-
tem will reject the call. When set between 1 and 98, if a call comes in that
matches DID digits and DGT field then the system counts the same DID digits,
and if the count is the same or higher than this value, the system sends busy
signal to caller.
DC The number of digits to delete. This is useful with Tandem switching,
mixed numbering plans and DID Repeat digits over tie line. Maximum
number of digits that can be deleted is 16.
NAME Enter up to 11 characters to identify call. Refer to MMC 104, STATION
NAME, for how to enter the name.
TONE Assigns ring tone to DLI port.
CADENCE Assigns ring cadence to SLT port.