Filter
Top Products
OfficeServ 7100 Call Server Programming Guide
Samsung Business Communications 2-169
(continued)
No Option Description
2 OVERFLOW This is the timer value that will cause unanswered calls to a group to
begin also ringing the NEXT PORT(see below) after this timer has
elapsed. If set to 000, no overflow will take place.
3 GROUP
TRANSFER
This is a timer that will determine how long Trunk Line calls transferred
to the group will ring at the group before recalling. If set to 000, no recall
will take place.
4 NEXT PORT This is the station or group number that callers will also ring at if the OVER-
FLOW feature has been programmed. The OVERFLOW DESTINATION
can be defined as:
1 COMMON BELL There is a common bell port on each MIS card.
2 RING OVER PAGE The ROP port can be defined as the NEXT port.
3 STATION OR STATION GROUP. Any station or station group can be
defined as the NEXT port.
5 MEMBER List all members that are to be in the group. Up to 32 members for the
system are allowed in each group, but stations can be assigned to mul-
tiple station groups.
6 NEXT HUNT The length of time a call will ring at a station before it hunts to the next
group member.
7 GROUP BUSY When this option is set to ON, a busy signal will be sent to the caller if
all group members are busy. When this option is set to OFF, the ring
back tone is sent to the caller even if all group members are busy. UCD
is an exception to this rule. This option only works when MMC 210 SGR
INC BUSY is set to OFF. When MMC 210 SGR INC BUSY is set to ON,
all station groups will follow this setting.
9 ALLOUT NEXT If all members are log-out, the call would be send to next port.
10 RBT MSG If set ON, coloring service can be used by using svmi message.
Calls to a group
Calls to a group do not follow the call forwarding instructions of any station in the
group.