Filter
Top Products
3G Storm Series
®
Wheelchairs 98 Part No. 1104849
FIGURE 13 - INSTALLING/REMOVING
FENDERS - STANDARD GEARLESS/
BRUSHLESS MOTORS BEFORE 1/26/04
SECTION 12 WHEELS/MOTORS
WHEELS/MOTORS
STANDARD GEARLESS/BRUSHLESS MOTORS BEFORE 1/26/04
(FIGURE 13)
Installing.
1. Remove the drive wheel. Refer to
REMOVING/INSTALLING THE DRIVE WHEELS
in this section of the manual.
2. Remove two (2) top mounting screws and flat washers (not shown) that secure the
gearless/brushless motor to the suspension arm. Discard flat washers.
3. Secure the gearless/brushless fender bracket to the suspension arm, in the
orientation shown, using the two (2) mounting screws removed in STEP 2. Torque
mounting screws to 160 in-lbs.
4. Secure the fender and spacer to the gearless/brushless fender bracket, in the orien-
tation shown, with the two (2) pan head tap screws provided. Securely tighten.
5. Reinstall the drive wheel. Refer to
REMOVING/INSTALLING THE DRIVE WHEELS
in this section of the manual.
Removing.
1. Remove the drive wheel. Refer to REMOVING/INSTALLING THE DRIVE WHEELS
in this section of the manual.
2. Remove two (2) top mounting screws that secure the fender bracket and gearless/
brushless motor to the suspension arm.
3. Secure the gearless/
brushless motor and two
(2) flat washer to the
suspension arm using the
two (2) exisiting mounting
screws. Torque mounting
screws to 160 in-lbs.
4. Reinstall the drive wheel.
Refer to REMOVING/
INSTALLING THE DRIVE
WHEELS in this section of
the manual.
Pan Head
Tap Screws
Two (2) Top
Mounting Screws
Suspension Arm
Gearless/Brushless
Fender Bracket
Spacer
Fender