Filter
Top Products
Part No. 1104849 73 3G Storm Series
®
Wheelchairs
GROUP 24 BATTERY BOXES FOR WHEELCHAIRS EQUIPPED
WITH VENT TRAY (FIGURE 9)
WARNING
Each battery weighs 51 pounds. Use proper lifting techniques (lift with your
legs) to avoid injury.
Removing.
1. Place the wheelchair in a well ventilated area where work can be performed without
risking damage to carpeting or floor covering.
2. Verify the joystick ON/OFF switch is in the OFF position.
3. Pull the battery box retainer UP over the end of the one (1) connector battery box.
4. Slide one (1) connector battery box along the sub-frame and remove from the wheelchair.
5. Slide the two (2) connector battery box along the sub-frame and remove from the wheelchair.
Installing.
1. Place the wheelchair in a well ventilated
area where work can be performed
without risking damage to carpeting or
floor covering.
2. Verify the joystick ON/OFF switch is in
the OFF position.
3. Secure the battery box carrying strap
to the lid of the two (2) connector
battery box.
4. Place two (2) connector battery box
onto the battery sub-frame assembly
with guide pins facing the inside of the
wheelchair.
5. Slide the two (2) connector battery
box along the sub-frame until its guide
pins are engaged in the sub-frame
connector.
NOTE: Visually inspect to ensure the
connection is properly made. Connectors
MUST be fully engaged.
NOTE: Make certain that the battery box
carrying strap is positioned on top of the
battery box and will not interfere with the one
(1) battery box guide pins when engaging the
connector on the one (1) battery box lid.
6. Secure the battery box carrying strap
to the lid of the one (1) connector
battery box.
Battery Box
Retainer Bar
One (1) Connector Battery Box
Two (2)
Connector
Battery Box
Base
Frame
Battery Box
Sub-Frame
Two (2) Connector
Battery Box
Battery Box
Sub-Frame
FIGURE 9 - REMOVING/
INSTALLING BATTERY BOXES -
GROUP 24 BATTERY BOXES FOR
WHEELCHAIRS EQUIPPED WITH
VENT TRAY
Battery Box
Retainer Bar
One (1) Connector Battery Box
Base
Frame
BATTERIES
BATTERIES
SECTION 9