Filter
Top Products
3G Storm Series
®
Wheelchairs 32 Part No. 1104849
SEAT FRAME
CHANGING SEAT DEPTH
STANDARD SEAT FRAME
NOTE: Review the chart below. This will determine the components needed to obtain the
desired seat depth.
SEAT FRAME COMPONENTS
CJ BACK SEAT
SEAT BRACKETS SEAT FRAME
DEPTH REQUIRED PAN DEPTH
12-inches
to YES 17-inch 16-inch deep
15-inches
16-inches NO 16-inch 16-inch deep
17-inches NO 17-inch 16-inch deep
18-inches NO 18-inch 18-inch deep
19-inches NO 19-inch 18-inch deep
20-inches NO 20-inch 20-inch deep
21-inches NO 21-inch 20-inch deep
22-inches NO 22-inch 22-inch deep
COMPONENT IDENTIFICATION TABLE
FOR STANDARD SEAT FRAME
1. Find current seat depth in left
hand column in the chart.
2. Follow that row to right under
seat frame components.
3. Verify and note the
components of the current seat
depth.
4. Repeat STEPS 1-3 for your
desired seat depth.
5. Compare existing components
of the current seat depth and
the required components for
the desired seat depth.
6. Perform one (1) of the following:
A. If the current seat depth and
the desired seat depth is within the 12 to 15-inch seat depth range, this change
can be accomplished by repositioning the back canes on the CJ back brackets.
Refer to CHANGING SEAT DEPTH BETWEEN 12 AND15-INCHES in this
section of the manual.
B. If the desired change only requires a NEW seat pan, refer to REMOVING/
INSTALLING SEAT PAN in this section of the manual.
C. For all other seat depth changes, perform the following:
PREPARATION FOR REMOVING/INSTALLING SEAT FRAME (STANDARD
FRAME, ASBA, AND VAN SEAT) in this section of the manual.
Perform one (1), two (2), or all three (3) of the procedures listed below depending
on the components required for the desired seat depth determined from STEPS 1-5:
REMOVING/INSTALLING CJ BACK BRACKETS in SECTION 8 of this
manual.
REMOVING/INSTALLING STANDARD SEAT SUBASSEMBLY in this
section of the manual.
REMOVING/INSTALLING SEAT PAN in this section of the manual.
After completing the procedure(s) listed above, perform the steps outlined in
PREPARATION FOR REMOVING/INSTALLING SEAT FRAME (STANDARD
FRAME, ADJUSTABLE FRAME, AND VAN SEAT) to complete the desired seat
depth change.
SECTION 6 SEAT FRAME