Filter
Top Products
3G Storm Series
®
Wheelchairs 50 Part No. 1104849
4. Remove the two (2) mounting screws that secure the battery charger connector to
the mount bracket.
5. Remove battery charger connector from mount bracket.
6. Remove the mounting screw which secures the battery charger mount bracket to
the T-nut located in the channel of the base frame.
7. Replace battery charger mount
bracket and secure to base
frame with existing mounting
screw.
NOTE: To replace the Battery Charger
Bracket T-Nut, perform STEPS 3-13 in
REPLACING SEAT SUPPORT BRACKET
T-NUTS in this section of the manual.
8. Secure the battery charger
connector to the mount
bracket with the EXISTING
two (2) mounting screws.
Tighten securely.
9. Reverse STEP 2.
10. Perform the instructions outlined in PREPARATION FOR REMOVING/INSTALLING
SEAT FRAME (STANDARD FRAME, ASBA, AND VAN SEAT) in SECTION 6 of this
manual.
REMOVING/INSTALLING SEAT STOP SCREWS (FIGURE 5)
NOTE: The front seat stop screw should only be removed if replacing a T-nut for either the seat support
bracket or the battery charger mount bracket. The rear seat stop screw should never be removed.
1. Unthread seat stop screw from base frame.
WARNING
The seat stop screws must be in place before operation of your power
wheelchair. Ensure the seat support bracket is positioned between both
seat stop screws.
2. When reinstalling the front seat stop screw, ensure the seat support bracket is
located in-between both seat stop screws. Use loctite 242 and tighten securely.
FIGURE 4 - REPLACING BATTERY
CHARGER BRACKET AND T-NUT
Battery
Charger
Connector
Battery
Charger
Mount
Bracket
Base
Frame
T-Nut
Mounting Screw
FIGURE 5 - REMOVING/INSTALLING SEAT STOP SCREWS
Base
Frame
Front Seat Stop Screw
Rear Seat
Stop Screw
Seat Support Bracket
BASE FRAMESECTION 7
BASE FRAME