Filter
Top Products
3G Storm Series
®
Wheelchairs 68 Part No. 1104849
WHEELCHAIRS EQUIPPED WITH
MCC-MARK IV JOYSTICK
WHEELCHAIRS EQUIPPED WITH
MARK IV RII JOYSTICK
From
Battery
Charger
Battery Charger Connector
From Battery
Charger
Three (3)
Pronged Plug
Battery Charger
Battery Boxes
Base Frame
Battery Charger Mount Bracket
Support
Plate
Battery Charger
Port
FIGURE 7 - CHARGING BATTERIES
NOTE: This joystick is available only on the
Torque SP.
FRONT VIEW OF
JOYSTICK
Charger Port
Battery Charger
Three (3) Pronged Plug
From Battery
Charger
Charger
Port
Joystick
Battery
Boxes
USING BATTERY CHARGERS
1. Perform one (1) of the following:
A. WHEELCHAIRS EQUIPPED WITH MCC-MARK IV JOYSTICK - Attach
the battery charger connector to the charger cable/battery harness.
NOTE: The battery charger connector is factory installed on the RIGHT side of the wheelchair.
It can be positioned on either side of the wheelchair for user convenience.
NOTE FOR RECLINERS ONLY: If the wheelchair is a recliner, the battery charger connector as
well as the limit switch, are factory set on the RIGHT side of the wheelchair. However, they can
be positioned on either side for user convenience. The limit switch MUST BE positioned on the
same side as the battery charger connector.
B. TORQUE SP EQUIPPED WITH MARK IV RII JOYSTICK - Attach the
battery charger connector to the charger port on the FRONT of the joystick.
2. Plug the charger’s AC power cord, or extension, into the grounded 120 VAC wall outlet.
3. Wait until charging is complete.
NOTE: It is advantageous to recharge frequently rather than only when necessary. In fact, a
battery’s life is extended if the charge level is maintained well above a low condition.
NOTE: If the batteries need to be charged more often or take longer to charge than normal,
they may need to be replaced. Contact an Invacare dealer for service.
BATTERIESSECTION 9
BATTERIES
Charger Cable