Filter
Top Products
Part No. 1104849 33 3G Storm Series
®
Wheelchairs
ASBA (FIGURE 3)
NOTE: Review the chart below. This will determine the components needed to obtain your
desired seat depth.
1. Find current seat depth in left
hand column in the chart.
2. Follow that row to right under
seat frame components.
3. Verify and note the components
of the current seat depth.
4. Repeat STEPS 1-3 for the
desired seat depth.
5. Compare existing components
of the current seat depth and
the required components for
the desired seat depth.
To adjust the depth of the seat on
the wheelchair, use the following
guidelines:
If the current seat depth is and the
desired seat depth are within the 12
to 15-inch seat depth range, this
change can be accomplished by
repositioning the back canes on the
CJ back brackets. Refer to CHANGING SEAT DEPTH BETWEEN 12 AND15-INCHES in
this section of the manual.
If the desired change only requires a new seat pan, refer to REMOVING/INSTALLING
SEAT PAN in this section of the manual.
If the desired change requires the removal/installation of CJ back brackets, refer to
REMOVING/INSTALLING CJ BACK BRACKETS in SECTION 8 of this manual.
If the desired change requires a new side frame, and/or new center frame, perform the
following steps:
A. Perform the instructions outlined in SEAT FRAME REMOVING/INSTALLING
PREPARATION FOR STANDARD FRAME, ASBA, AND VAN SEAT in this
section of the manual.
NOTE: Note the mounting hole position of side frame for proper installation of NEW side frame.
B. Remove the two (2) mounting screws, coved washers, spacers, and locknuts that
secure the side frame to the center frame.
C. Remove the side frame from the center frame.
D. Repeat STEPS A and B for opposite side frame.
NOTE: If the desired seat depth requires a new center frame, determined in STEPS 1-5
perform STEPS E - G, otherwise proceed to STEP H.
NOTE: Note the four (4) different lengths of side frames
short, medium, long, and X-long, as well as the two different
center frames, short and long. These components are
interchanged to obtain the various different seat depths.
SEAT FRAME COMPONENTS
CJ BACK
SEAT BRACKETS SEAT SIDE CENTER
DEPTH REQUIRED PAN FRAME FRAME
12-inches
to YES 17-inch Short Short
15-inches
16-inches NO 16-inch Short Short
17-inches NO 17-inch Short Short
18-inches NO 18-inch Medium Short
19-inches NO 19-inch Medium Short
20-inches NO 20-inch Long Long
21-inches NO 21-inch Long Long
22-inches NO 22-inch X-Long Long
COMPONENT IDENTIFICATION TABLE
FOR STANDARD SEAT FRAME
SEAT FRAME SECTION 6
SEAT FRAME