Filter
Top Products
3G Storm Series
®
Wheelchairs 110 Part No. 1104849
9. Secure limit switch sensor to the seat frame with the two (2) mounting screws and washers.
10. Secure the wire retainer onto the INSIDE of the seat frame with the mounting screw.
11. Tie wrap the limit switch wire to the seat frame.
12. Adjust the limit switch. Refer to
ADJUSTING LIMIT SWITCH in this section of the
manual.
Mounting
Screws
Mounting Screws
(DO NOT Overtighten)
Actuator
Tie Wraps
Wire
Retainer
Limit Switch
Sensor
Seat
Frame
Mounting Screws
(DO NOT Over Tighten)
Washers
Limit Switch
Sensor
FIGURE 1 - POSITIONING LIMIT SWITCH
Gas Cylinder
Pivot Block
Actuator
Washers
ADJUSTING LIMIT SWITCH (FIGURE 2)
WARNING
NEVER operate the wheelchair while in any recline position over 105
o
RELATIVE
TO THE SEAT FRAME. If the limit switch does not stop the wheelchair from
operating in a recline position greater than 105
o
RELATIVE TO THE SEAT
FRAME, do not operate the wheelchair. Adjust the limit switch BEFORE using the
wheelchair, otherwise injury or damage can occur.
1. Recline the back of the wheelchair until the gas cylinder rod measures 3-21/32 of an inch.
2. Turn the power of the joystick to the ON position.
NOTE: ALL segments of the bar graph on the joystick should start to flash on and off and the
wheelchair should not operate.
3. IF the wheelchair operates, proceed to the following steps to adjust the actuator on
the gas cylinder pivot block:
A. Loosen, but do not remove, the two (2) mounting screws and washers that
secure the actuator to the gas cylinder pivot block.
B. Slide actuator UP (towards top of the wheelchair).
CAUTION
DO NOT over tighten the mounting screws that secure the actuator to
the pivot block. Damage to the actuator will occur.
SECTION 14 RECLINER
RECLINER
Mounting Screw
(DO NOT Overtighten)