Filter
Top Products
3G Storm Series
®
Wheelchairs 80 Part No. 1104849
B. Loosen, but do not remove, the two (2) phillips screws, washers and locknuts
that secure the actuator to the upper limit switch bracket.
C. Slide the actuator UP (towards the top of the wheelchair).
CAUTION
DO NOT over tighten the phillips screws that secure the actuator to the
upper limit switch bracket. Damage to the actuator can occur.
D. Only tighten the two (2) phillips screws, washers and locknuts that secure the
actuator to the upper limit switch bracket until the actuator does not move.
E. Repeat STEPS 1-3 until the wheelchair does not operate when the van seat back
is at a 24
o
angle.
SECTION 10 WIRING HARNESS
WIRING HARNESS