Filter
Top Products
Part No. 1104849 107 3G Storm Series
®
Wheelchairs
ELECTRONICS
SECTION 13ELECTRONICS
REMOVING GB CONTROLLER (WHEELCHAIRS EQUIPPED
WITH 2ND GENERATION POWERED SEATING SYSTEMS)
(FIGURE 5)
1. Remove the battery boxes. Refer to REMOVING/INSTALLING THE BATTERY
BOXES in SECTION 9 of this manual.
2. Remove the controller shroud (if applicable).
3. Remove the TRCM controller (if applicable). Refer to
REPLACING THE TILT AND
RECLINE CONTROL MODULE (TRCM) in Tilt and Recline Service Manual, part
number 1090208.
4. Remove the 5/16-18 x 1-inch hex head cap screw that secures the jumper cable and
controller bracket to the base frame.
5. Remove the 5/16-18 x 1-inch hex head cap screw that secures the controller
bracket to the base frame.
6. Remove the 10-32 x 1/2-inch mounting screw and two (2) lockwashers that secures
the front of the GB controller and jumper cable to the controller bracket.
7. Remove the two (2) 8-32 x 1/2-inch mounting screws that secure the rear of the GB
controller to the controller bracket.
INSTALLING GB CONTROLLER (WHEELCHAIRS EQUIPPED
WITH 2ND GENERATION POWERED SEATING SYSTEMS)
(FIGURE 5)
1. Secure the rear of the GB controller to the controller bracket with two (2) of the
NEW 10-32 x 1/2-inch mounting screws. Securely tighten.
2. Secure the front of the GB controller and one end of the jumper cable to the
controller bracket with one (1) of the NEW 10-32 x 1/2-inch mounting screw and
lockwasher. Securely tighten.
3. Secure one side of the controller bracket to the base frame with one (1) of the
NEW 5/16-18 x 1-inch hex head cap screws. Securely tighten.
4. Secure the other side of the controller bracket and opposite end of jumper cable to the
base frame one (1) of the NEW 5/16-18 x 1-inch hex head cap screws. Securely tighten.
5. Reinstall the TRCM controller (if applicable). Refer to REPLACING THE TILT AND
RECLINE CONTROL MODULE (TRCM) in Tilt and Recline Service Manual, part
number 1090208.
6. Reinstall the controller shroud (if applicable).
7. Reinstall the battery boxes. Refer to REMOVING/INSTALLING THE BATTERY
BOXES in SECTION 9 of this manual.