Filter
Top Products
Part No. 1104849 45 3G Storm Series
®
Wheelchairs
Mounting Screw
Medium Height
Seat Mount Plate
Front of
Seat Frame
Mounting
Screw
Rear of Seat Frame
DETAIL “A”
FIGURE 10 - SEAT ANGLE
ADJUSTMENT
SEAT ANGLE ADJUSTMENT (FIGURE 10)
NOTE: The angle of the seat is factory set providing the user with a 5
o
seat dump. This angle
can be changed by adjusting either the front or back of the seat mount plate to obtain any
angle between 0
o
or 10
o
seat dump.
NOTE: There are three (3) heights of seat mounting plates; low, medium, and high.
1. To obtain a 0
o
seat dump (DETAIL “A”):
A. Loosen the two (2) mounting screws that secures the seat mount plate to the
seat support bracket.
B. Loosen the two (2) mounting screws that secures the remaining seat mount plate
to the seat support bracket.
C. Adjust the seat mount plates so that the rear mounting screws are positioned at
the bottom of the rear slots.
D. Adjust the seat mount plates so
that the front mounting screws are
positioned at the top of the front
slots.
E. Securely tighten all four (4) mounting
screws. Torque to 156 in-lbs.
2. To obtain a 10
o
seat dump (DETAIL “A”):
A. Loosen the two (2) mounting
screws that secure the front of the
seat frame to the seat mount plate.
B. Position the mounting screws at
the bottom of the front slot.
C. Securely tighten both mounting
screws. Torque to 156 in-lbs.
LOW HEIGHT
MEDIUM HEIGHT HIGH HEIGHT
SEAT FRAME SECTION 6
SEAT FRAME