Filter
Top Products
3G Storm Series
®
Wheelchairs 122 Part No. 1104849
Spacer
Battery Mount
Bracket
*Rubber Element
(or Shock Assembly)
Mounting Screws
Base Frame
FIGURE 3 - REMOVING 22NF COMPONENTS
*NOTE: Illustration depicts rubber element. Battery Mount
Brackets remove in the same manner for the shock assembly.
Locknut
Washer
RWD WHEELCHAIRSSECTION 15
RWD WHEELCHAIRS
INSTALLING GROUP 24 COMPONENTS (FIGURE 4)
1. Line up the mounting holes in the front of the NEW battery box sub-frame and the
NEW wiring harness w/bracket with the mounting holes in the base frame.
2. Install the two (2) mounting screws through the wiring harness w/bracket, battery
box sub-frame, and base frame.
3. Install the locknuts onto mounting screws. Torque to 160 in-lbs.
4. Perform one (1) of the following:
A. WHEELCHAIRS EQUIPPED WITH VENT TRAY
WARNINGWARNING
WARNINGWARNING
WARNING
The Battery Box Retainer/Retainer Clip MUST be fastened securely in
place before using the wheelchair. Use Loctite 242 and torque to 160 in-lbs.
Position the retainer clip between the NEW battery box sub-frame and the
top of the rubber element or shock assembly making sure the retainer clip
mounting hole is towards the bottom and the closed end of the clip is against
the battery box retainer bar.
NOTE: Make sure the closed end of the battery box retainer clip is pointing up.
Install the mounting screw that secures the retainer clip to the battery box
sub-frame. Use Loctite
®
242 and torque to 160 in-lbs.
Line up the NEW battery box retainer bar and spacers with mounting holes
in the base frame (FIGURE 5).
Reinstall the mounting screws that secure the battery box retainer bar to the
base frame. Use Loctite 242 and torque to 160 in-lbs (FIGURE 5).