Filter
Top Products
Part No. 1104849 79 3G Storm Series
®
Wheelchairs
ADJUSTING LIMIT SWITCH (FIGURE 3)
NOTE: The following section is for high back van seat model wheelchairs only.
WARNING
NEVER operate the wheelchair while in any recline position over 114
°
RELATIVE
TO THE SEAT FRAME. If the limit switch does not stop the wheelchair from
operating in a recline position greater than 114
°
RELATIVE TO THE SEAT
FRAME, DO NOT operate the wheelchair. Adjust the limit switch BEFORE using
the wheelchair, otherwise injury or damage can occur.
1. Place the wheelchair on a level surface.
2. Recline the van seat back to a 24
o
to achieve the 114
o
angle relative to the seat
frame. Refer to
ADJUSTING VAN SEAT in SECTION 6 of the Owner’s Manual, part
number 1104782 or 1123757.
NOTE: The van seat frame is at a 5
o
angle relative to the ground. When the back angle is
adjusted to 114
o
relative to the seat, it will measure 61
o
relative to the ground.
NOTE: To determine 114
o
back angle relative to the seat frame, place a magnetic protractor
(available at any hardware store) on the back as shown in FIGURE 2 and adjust the back until
the magnetic protractor reads 61
o
.
3. Turn the wheelchair power switch on the joystick to the ON position.
NOTE: The wheelchair should not operate.
4. IF wheelchair operates, proceed to the following steps to adjust the actuator on the
upper limit switch bracket:
A. Fully recline the back. Refer to ADJUSTING VAN SEAT in SECTION 6 of the Owner’s
Manual, part number 1104782 or 1123757.
NOTE: This will make access to the limit switch easier.
SECTION 10WIRING HARNESS
WIRING HARNESS
FIGURE 3 - ADJUSTING LIMIT SWITCH
Upper
Limit
Switch
Bracket
Phillips
Screws,
Washers
and
Locknuts
24
o
Back
Recline Angle
61
o
Magnetic Protractor - (Will read 61
o
when back recline angle is at 114
o
relative to the seat frame)
5-3/4-inches
5
o
Seat Angle
114
o