Filter
Top Products
Part No. 1104849 39 3G Storm Series
®
Wheelchairs
4. Remove the four (4) mounting screws and locknuts that secure the center frame to
the support brackets.
5. Secure NEW center frame to support brackets with existing four (4) mounting
screws and locknuts. Torque to 156 in-lbs.
WARNING
Both side frames MUST be adjusted to the same mounting hole position to
maintain proper weight balance of user and seat frame. If weight is not
balanced, injury to the assistant and/or user and damage to the wheelchair
may result.
6. Install new/existing side frame(s) into new/existing center frame at the mounting
position previously noted. Torque to 75 in-lbs.
7. Perform the instructions outlined in PREPARATION FOR REMOVING/INSTALLING
SEAT FRAME (STANDARD FRAME, ASBA, AND VAN SEAT) in this section of the
manual.
Mounting Screws
(Torque to
156 in-lbs)
Side Frame
Side Frame
Center Frame
Spacer
Locknuts
Support
Bracket
Base
Frame
Coved Washer
Locknuts
Support
Bracket
Mounting Screws
(Torque to
156 in-lbs)
Mounting Screws
(Torque to
156 in-lbs)
Mounting Plate
Mounting Screws
(Torque to
75 in-lbs)
Mounting Screws
(Torque to
156 in-lbs)
Locknuts
FIGURE 6 - INSTALLING/REMOVING ASBA SUBASSEMBLY AND/OR
COMPONENT REPLACEMENT
SECTION 6SEAT FRAME
SEAT FRAME