Filter
Top Products
3G Storm Series
®
Wheelchairs 84 Part No. 1104849
REMOVING
1. Remove the battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES
in SECTION 9 of this manual.
2. Remove the four (4) beveled hex nuts that secures the drive wheel assembly to one
of the following: drive wheel hub, GB motor spacer or adapter plate with studs.
3. Remove existing drive wheel assembly from wheel hub.
INSTALLING
1. Reinstall new/existing drive wheel assembly to one (1) of the following: drive wheel
hub, GB motor spacer or adapter plate with studs and torque the four (4) beveled
hex nuts to 160-inch pounds.
2. Repeat procedure for opposite side of wheelchair, if necessary.
3. Reinstall the battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES in
SECTION 9 of this manual.
WHEELS/MOTORSSECTION 12
WHEELS/MOTORS
FIGURE 1 - REMOVING/INSTALLING DRIVE WHEELS
CONVENTIONAL MOTOR
WITH GEARBOX
GEARLESS/BRUSHLESS MOTOR
Four (4) Beveled Hex Nuts
Drive Wheel
Assembly
Drive Wheel
Hub
Motor/Gearbox
Assembly
Drive Wheel
Assembly
Four (4) Beveled Hex Nuts
GB Motor
Spacer
Drive Wheel
Hub
14 X 3-INCH WHEEL
14 X 4-INCH WHEEL
Four (4) Beveled Hex Nuts
Drive Wheel
Assembly
Drive Wheel
Hub
Motor/Gearbox
Assembly
Four (4) Beveled Hex Nuts
Drive Wheel
Assembly
Adapter Plate
With Studs
G/B Motor
G/B Motor
WHEELCHAIRS BUILT
BEFORE 1/26/04 ONLY