Filter
Top Products
Part No. 1104849 37 3G Storm Series
®
Wheelchairs
WARNING
Both side frames MUST be adjusted to the same mounting hole position to
maintain proper weight balance of user and seat frame. If weight is not balanced,
injury to the assistant and/or user and damage to the wheelchair may result.
6. Repeat STEPS 3-5 for opposite side frame.
7. Perform one (1) of the following:
A. For adjusting the seat width only, perform the instructions outlined in
PREPARATION FOR REMOVING/INSTALLING SEAT FRAME (STANDARD
FRAME, ASBA, AND VAN SEAT) in this section of the manual.
NOTE: When performing the steps outlined in
PREPARATION FOR REMOVING/INSTALLING SEAT
FRAME (STANDARD FRAME, ASBA, AND VAN SEAT) the seat pan, seat cushion, back upholstery
and spreader bar (if applicable), will need to be replaced. Spreader bars are only required on seat
depths greater than 19-inches.
B. For all other changes regarding seat frame changes, refer back to the starting
procedure to complete the desired change.
FIGURE 5 - CHANGING SEAT WIDTH - ASBA
STEPS 3-6
Side Frame
Center
Frame
Mounting
Screws
Coved
Washers
Spacers
DETAIL “A”
12-inches
13-inches
14-inches
15-inches
16-inches
Locknut
Side
Frame
SECTION 6SEAT FRAME
SEAT FRAME