Filter
Top Products
Part No. 1104849 97 3G Storm Series
®
Wheelchairs
SECTION 12WHEELS/MOTORS
WHEELS/MOTORS
Removing.
1. Remove the drive wheel. Refer to
REMOVING/INSTALLING THE DRIVE WHEELS
in this section of the manual.
NOTE: When performing STEPS 2 and 3, only the two (2) mounting screws on the side of the
suspension arm where the drive wheel mounts need to be removed in order to remove the fender.
2. Remove the LONGER mounting screw that secures the rear of motor/gearbox to
the suspension arm.
3. Remove the SHORTER mounting screw and lock washer (if applicable) that secures
the rear of motor/gearbox to the suspension arm.
CAUTION
The longer mounting screws MUST be used to secure the REAR of the
gearbox to the suspension arm and the SHORTER mounting screws
MUST be used to secure the FRONT of the gearbox to the suspension
arm - otherwise, damage to the gearbox casting can result.
4. Secure the rear of the suspension arm to the motor/gearbox using the LONGER
mounting screw removed in STEP 2. Torque mounting screw to 160 in-lbs.
5. Secure the front of the suspension arm to the motor/gearbox using the SHORTER
mounting screw and lock washer (if applicable) removed in STEP 3. Torque mounting
screw to 160 in-lbs.
6. Reinstall the drive wheel. Refer to REMOVING/INSTALLING THE DRIVE WHEELS
in this section of the manual.