Filter
Top Products
Part No. 1104849 81 3G Storm Series
®
Wheelchairs
RETENTION STRAP/RETAINER SECTION 11
This Section Includes the Following:
Replacing Battery Box Retainer Bar/Retainer Clip
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
REPLACING BATTERY BOX RETAINER BAR/RETAINER
CLIP (FIGURE 1)
1. Remove the battery box. Refer to REMOVING/INSTALLING BATTERY BOXES in
SECTION 9 of this manual.
REPLACING RETAINER CLIP
1. Remove the mounting screw that secures the retainer clip and shock (or rubber
element) to the base frame.
2. Remove the existing retainer clip.
3. Position the NEW retainer clip between the shock (or rubber element) and the
battery box sub-frame as shown in FIGURE 1. Make sure the angled end of the
retainer clip is facing up.
WARNING
The Battery Box Retainer Bar/Retainer Clip MUST be fastened securely in place
before using the wheelchair. Use Loctite 242 and torque to 160 in-lbs.
4. Reinstall the mounting screw that secures the retainer clip and shock (or rubber
element) to the base frame. Use Loctite 242 and torque to 160 in-lbs.
5. Reinstall the battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES in
SECTION 9 of this manual.
REPLACING RETAINER BAR
1. Remove the two (2) mounting screws and spacers that secure the battery box
retainer bar to the base frame.
2. Pull up on the battery box retainer bar to remove it from the base frame.
3. Install the two (2) existing spacers through the mounting holes in the NEW battery
box retainer bar.
WARNING
The Battery Box Retainer Bar/Retainer Clip MUST be fastened securely in place
before using the wheelchair. Use Loctite 242 and torque to 160 in-lbs.
4. Line up the NEW battery box retainer bar and spacers with the mounting holes in
the battery box sub frame and the base frame.
5. Reinstall the mounting screws that secure the battery box retainer bar between battery
box sub frame and the base frame. Use Loctite 242 and torque to 160 in-lbs.
6. Reinstall both battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES
in SECTION 9 of this manual.
RETENTION STRAP/RETAINER