Filter
Top Products
7. Remote I/O Unit Connection
7.11 Connection of FCUA-DX13* Unit and Handle
65
7.11 Connection of FCUA-DX13* Unit and Handle
To connect the manual pulse generator, the R041 or R042 cable is connected to "HANDLE". Up to two
manual pulse generators can be connected. When manufacturing the R041 or R042 cable, use the
connector set CS000 (optional, with two ends). (Refer to Appendix 2.4 R041 Cable, and Appendix 2.5
R042 Cable for cable details.)
HANDLE
FCUA-DX13*
Manual pulse generator
FCUA-HD60
Rear view
4-M3
NO.1
R041 cable
To Connect one manual pulse generator
To connect two manual pulse generators
Manual pulse generator
FCUA-HD60
Rear view
12V A0V B
4-M3
SEL*
NO.1
NO.2
HANDLE
FCUA-DX13*
1
10
11
20
Pin No.
R042 cable
12V A0V B
12V A0V B
When connecting the second manual pulse generator, connect the SEL* signal to the No. 1's 0V.
Incorrect connections could damage the device, so always connect the cable to the
designated connector.
Do not connect or disconnect the connection cables between each unit while the power
is ON.
CAUTION