Filter
Top Products
4. NC Card (HR621/HR623/FCU6-HR655) Connection
4.4 ISA NC Card Mounting
26
(6) Following the instructions in the personal computer manual, install the personal computer cover
removed in mounting step 2.
(7) Reconnect the personal computer power cables.
(Note) Do not turn the personal computer ON yet.
(8) Connect the two relay cables (F010 and F011) to the two connectors (CF10 and CF61) on the card
installation metal fitting section of the ISA NC Card.
(Note) Connect the F010 cable to the CF10 connector, and the F011 cable to the CF61 connector.
(9) Connect the F010 and F011 cables to the base I/O unit and relay card.
(Note) Connect the F010 cable to the CF10 connector on the base I/O unit, and the F011 cable to
the CF61 connector on the relay card.
This completes the ISA NC Card (HR621/623) mounting.
(10) Install the MELDASMAGIC64 software into the personal computer while the ISA NC Card is
mounted.
(Note) Install the software and mount the NC Card following the Setup Instruction Manual
(BNP-B2191).