Filter
Top Products
4. NC Card (HR621/HR623/FCU6-HR655) Connection
4.5 PCI NC Card Mounting
28
4.5.2 PCI NC Card Mounting Procedure
Install the software and mount the NC Card following the Setup Instruction Manual (BNP-B2191).
The software will not be installed correctly if the software installation and NC Card mounting procedure
are mistaken.
Mount the NC Card onto the personal computer with the following procedures.
(1) Set the rotary switch CDNO and slide switch SW1.
(Note) Before touching the NC Card, touch an exposed metal section of the personal computer to
discharge any static electricity.
Pay attention not to touch the NC Card, personal computer chip or circuit.
BAT
BAT
CDNO
SW1
CF63
CF62
Location of PCI NC Card (FCU6-HR655) switches
Roles of each switch
CDNO (rotary switch): Use to set the PCI NC Card's station No.
SW1 (slide switch): Use to set the PCI NC Card's power supply (internal/external).
BAT
BAT
SW1
CF63
CF62
M
L
Stabilized
power supply
+12V/+5V
AC FAIL
The default setting is "0".
The default setting is "L".
Connect a stabilized power supply to the CF62 and CF63 connectors
when using an external power supply.
CDNO setting
Switch Card
0 1st card
1 2nd card
2 3rd card
3 4th card
4 5th card
5 6th card
6 7th card
7 8th card
8 9th card
9 10th card
A 11th card
B 12th card
C 13th card
D 14th card
E 15th card
F 16th card
SW1 setting
Switch Supply method Details
L Internal supply
+5V/+12V is supplied by
PCI bus.
M External supply
+5V/+12V is supplied by
stabilized power supply.