Filter
Top Products
6. Relay Card (HR682) Connection
6.6 Installation on the Base I/O Unit
50
6.6 Installation on the Base I/O Unit
A relay card (HR682) can be added on to the base I/O unit. When adding on, install the card using the
following procedure.
Adding on is only possible with the FCU6-DX2** base I/O unit.
Note that adding on is not possible with the FCU6-DX3** and 4**.
1. Remove screw 1 from the base I/O unit. (Fig. 1)
2. Remove screw 2 of the relay card and spacer 1 (screw holes at both ends are female). (Fig. 2)
3. Install the attached spacer 2 (screw holes on one side are male) to the hole of screw 1 that was
removed from the base I/O unit. (Fig. 3)
4. Mount the relay card on the base I/O unit, and fix with screw 1 that was removed in step 1. (Fig. 4)
5. Turn the unit over, and fix the screws at the three holes to the three spacer locations. (Fig. 5)
This completes the installation of the relay card to the base I/O unit.
0 0
CF31CF32
CF34CF33
0 0
CF31CF32
CF34CF33
0 0
CF31CF32
CF34CF33
Remove screw 1.
Remove screw 2
and spacer 1.
Fig. 1
Install spacer 2.
Install screw 1.
Turn the unit over,
and fix the screws
at the three locations.
Fig. 2
Fig. 3 Fig. 4
Fig. 5