Filter
Top Products
Reference Manual
00809-0100-4665, Rev AA
August 2010
Rosemount 8732
www.rosemount.com
Section 3 Configuration
Quick Start-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-1
Assigning Device Tag and Node Address . . . . . . . . . . . . page 3-2
Basic Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-2
This section covers basic operation, software functionality, and basic
configuration procedures for the Rosemount 8732E Magnetic Flowmeter
Transmitter with Profibus PA. For more information about the Profibus PA
technology and the function blocks used in the transmitter, refer to
Appendix F: Physical Block and Appendix G.
Calibration Rosemount sensors are wet calibrated at the factory. They do not need
further calibration during installation.
Each Profibus PA configuration tool or host device has a different way of
displaying and performing configurations. Some will use Device Descriptions
(DD) and DD Methods to make configuring and displaying data consistent
across host platforms. There is no requirement that a configuration tool or
host support these features. This section describes how to reconfigure the
device manually.
QUICK START-UP Once the magnetic flowmeter system is installed and communication is
established, configuration of the transmitter must be completed. The standard
transmitter configuration, without Option Code C1, Custom Configuration, is
shipped with the following parameters:
Sensor
Calibration Number
A unique sensor calibration number, imprinted on the sensor tag, enables any
Rosemount sensor to be used with any Rosemount transmitter without further
calibration. Rosemount flow lab tests determine individual sensor output
characteristics. The characteristics are identified by a 16-digit calibration
number. In a Profibus PA environment, the 8732E can be configured using an
8732E Profibus PA LOI or a Simatic PDM. Please see Section 4 for 8732E PA
LOI and PDM information.
Engineering Units: ft/s
Sensor Size: 3-in.
Sensor Calibration Number: 100000501000000