Filter
Top Products
Reference Manual
00809-0100-4665, Rev AA
August 2010
G-3
Rosemount 8732
78 EP_TRIG_COUNTS Number of EP measurements that must be
above the trigger level to set empty pipe.
79 EP_TRIG_LEVEL Empty Pipe Trigger Level.
80 EP_VALUE Value of the Empty Pipe measurement.
(Same scale as EP_TRIG_LEVEL).
81 ELECT_TEMP Compensated electronics temperature with
status.
82 TEMPERATURE_UNITS See section Engineering Units for supported
unit codes.
83 DSP_SOFTWARE_REV_NUM DSP software Rev Number - major, minor,
build.
84 PERFORM_AUTO_ZERO Perform auto zero calibration routine
Note1: Writing anything but a 2 has no effect.
Reads will always return a 1 or a 2.
85 PERFORM_ELECTRONICS_TRIM Perform input trim calibration routine
Note1: Writing anything but a 2 has no effect.
Reads will always return a 1 or a 2.
86 FLOW_TUBE_TAG Text string identifier of sensor.
87 FLOW_TUBE_SERIAL NUMBER Sensor serial number from physical tag on
sensor.
88 LINER_MATERIAL Enumerated string indicating liner material of
installed sensor.
89 ELECTRODE_MATERIAL Enumerated string indicating electrode
material of installed sensor.
90 ELECTRODE_TYPE Enumerated string indicating electrode type of
installed sensor.
91 FLANGE_TYPE Enumerated string indicating flange type of
installed sensor.
92 FLANGE_MATERIAL Enumerated string indicating flange material
of installed sensor.
93 Reserved Reserved.
94 DIAG_SNR_5HZ Signal to Noise ratio at 5 Hz.
95 DIAG_SNR_37HZ Signal to Noise ratio at 37.5 Hz.
96 Reserved Reserved.
97 LINE_NOISE 50/60 Hz line noise
98 DIAGNOSTIC_HANDLING On/off handling for diagnostics.
99-108 Reserved Reserved.
109 SP_CONTROL Signal Processing Control Code.
110 SP_NOISE_MODE Noise Mode.
111 SP_NUM_SAMPS Signal Processing Number of Samples.
112 SP_PERCENT_LIMIT Signal Processing Percent Limit
113 SP_TIME_LIMIT Signal Processing Time Limit
114 LICENSE_KEY Key/password to enable diagnostic features.
Any changes to the licensing will be shown in
the LICENSE_STATUS parameter.
115 LICENSE_STATUS Bit mask that shows which diagnostics are
licensed.
116 METER_VERIF_TEST_SCOPE Scope of the Flowmeter Verification Test.
Note: This parameter needs to be configured
before the Meter Verification is started via the
PERFORM_METER_VERIFY parameter.
Index Parameter Name Description