Filter
Top Products
93
8. Operation
Set the stops via
fixed function buttons on stand
Leica Application Suite (LAS) Software
Summary of pictograms
lower focus stop not set
lower focus stop set
focus position not set
focus position set
Going to the stops
Go to the lower stop by pressing and holding the
Z
↓ button.
Go to the focus position by pressing and holding
the Z
↑ button.
These functions can be assigned to variable
function buttons on the stand or SmartMove, or
they can be controlled via software.
Go to stops via
fixed function buttons on stand
variable function buttons on stand and
SmartMove
Leica Application Suite (LAS) Software
Note:
When going to the stops with the Z
↑ and Z↓ but-
tons, hold the button until the stop has been
reached.
Setting the step increments
It is possible to toggle between Fine and Coarse
step increments.
The Fine value varies to suit the
current objec-
tive. Suitable values have been predefined. The
assignments can be changed with the Leica Ap-
plication Suite (LAS).
When selecting Coarse, the positioning speed is
the same for
all objectives. Coarse corresponds
to the maximum speed.
Note:
The assignment of a specific step increment to
an objective not only applies to the Z drive, but
also to the step increments assigned to the
stage when Precise (→ p. 98) is selected.
Switch between Fine and Coarse via
variable function buttons on stand and
SmartMove
Leica Application Suite (LAS) Software