Filter
Top Products
43
6. Assembly
6.7 Installation of objectives
The positions in the objective turret disk are
numbered (Fig. 45). Depending on your equip-
ment, the individual objectives have already
been assigned to specific positions at the fac-
tory.
For details on the exact positions of the objec-
tives, please refer to the enclosed identifica-
tion sheet.
Caution:
Close vacant threads in the nosepiece with dust
protection caps!
Please note that the front lenses of the objec-
tives point upward and are therefore more vul-
nerable to contamination than those of upright
microscopes.
Check the front lenses for cleanliness fre-
quently.
Note:
Leica DMI6000B:
We recommend running a parfocality compen-
sation via the Leica Application Suite (LAS) soft-
ware.
6.6 Installation of eyepieces
The eyepieces are inserted into the eyepiece
tubes.
Note:
We recommend running a teach-in via the Leica
Application Suite (LAS) software when using
eyepieces not included in the scope of delivery.
This will ensure that the total magnification
shown in the LeicaScreen is correct.
Fig. 45a Objective turret Fig. 45b Objective turret, loaded
!
Fig. 44 Eyepieces